Jim Nickerson
Reged: Oct 16 2003
Posts: 60
Loc: San Diego, CA USA
|
|
When I switch to Universal ToolSuite only Picc 9.5 is available.
If I specify the location ( in Select Language Toolsuite or Set Language Tool Locations ) for 9.6 it does not stick.
If I revert to HI-TECH PICC Toolsuite I can specify the locations for 9.6 but of course the command line options are wrong.
Jim
--------------------
HI-TECH Certified Consultant
Microchip Authorized Design Partner
www.JimNickerson.org
|
Dan Henry
Guru
Reged: Oct 16 2003
Posts: 3861
Loc: Colorado
|
|
Open your project, then select Project / Build Options... / Project and click the Driver tab. You should see it listed under Available Drivers. Select what you want and click Move up or Move down to affect which toolchain is 'seen' first.
|
Jim Nickerson
Reged: Oct 16 2003
Posts: 60
Loc: San Diego, CA USA
|
|
Thanks Dan, I think I saw this mentioned before but I failed to remember it. All fine now.
Jim
--------------------
HI-TECH Certified Consultant
Microchip Authorized Design Partner
www.JimNickerson.org
|
Mark Pappin
Reged: Nov 01 2004
Posts: 599
Loc: Brisbane, Australia
|
|
Quote:
You should see it listed under Available Drivers.
And if you don't see it then you may have hit the activation problem seen recently, in which case you should contact support with the appropriate details so we can send you the necessary .REG file(s).
--------------------
Mark Pappin - HI-TECH Software
|
yang1006
stranger
Reged: Sep 02 2007
Posts: 10
|
|
removed spam
Edited by lucky (Sun Sep 02 2007 06:01 PM)
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
